The Best Way to Paste wallpaper at the corners: Directions, gluing outer, inner corner, docking

Step-by-step instructions to gluing inner corners

When finishing, the main problem can be irregular walls as well as the consequent folds on the wallpaper. It’s also required to take into consideration that if the walls are twisted , the joints of wallpaper canvases can invisibly.

After gluing the last one in the front of the interior corner of the cloth should measure the remaining space. It is measured from the edge of the pasted cloth to the adjoining wall, and the resulting amount is inserted 10-15 millimeters. If the walls are extremely curved, the further figure may be .

Cut a strip equivalent to the resultant figure, taking into account the allowance. The surfaces have been treated with adhesive. Based on the kind of coat it can be only the wall or the surfaces.

The strip has been glued independently using the cut side to the wallsocket. The background should go on the other plane.

In case the glued background is sterile, then you have to make a few small cuts perpendicular to the springs.

Level or incline on the adjoining wall is a vertical lineup. The distance from the corner is equivalent to the width of the former cut strip, not including developments.

The surfaces are smeared with glue, and then the coating is glued into the wall with the flat side towards the line. The cut goes on the adjacent wall.

Protruding corner ought to be pasted by analogy using gidpola.ru an inner, however there are little differences, which also have to be taken into consideration when working.

Measured the distance remaining out of the glued background to the adjacent wall. Insert 20-25 millimeters to the got figure.

A segment is cut away, considering the additional 20-25 millimeters.

Before gluing, the surfaces have been treated with adhesive.

The even edge has to be glued into the background fixed onto the wall, the own cut facet”goes” to the adjacent plane. If necessary, small cuts are created in the place of going to another background, smoothed and pressed to the wallsocket.

Draw a vertical strip on the adjacent wall in a distance of just glued cut strip and 6-10 millimeters.

After applying the glue, the strip is applied to the wall with its flat side into the line, going over the edge of this glued strip.

The joints have been smeared with glue and ironed using a rollercoaster. After that, the top layer is trimmed across the ruler and the two layers are joined together.